Animation speed option

Animation Speed in the Simulation Configuration is the speed to run a particular configuration animation. The default value of Animation Speed is 95%. You can adjust it to avoid problems with delay when the default speed is slow and large numbers of model elements are running. To run your animation at a pace that is faster or slower than the default animation speed, change the value of the Animation Speed option to your preferred one in the Specification window of the <<SimulationConfig>>.

The default animation speed in the Simulation Config is 95.

Animation Speed option in <<SimulationConfig>> is specified at a default value of 95%.

Note

Animation Speed shall NOT affect to animation in Parametric diagram, since no animation delay during parametric solving.

The Animation Speed setting is visible through diagram animation. For example, if the speed is specified at the value of 50%, the animation must be slower than the default value 95%. The speed setting is consistent with the Simulation speed bar control. For example, if the animation speed is specified at 50%, the speed bar is set to the middle as shown in the following figure.

The animation speed is consistent with the animation speed bar.

The animation speed selected is consistent with the animation speed bar.

Note

The speed of the animation does NOT affect the animation in the Parametric diagram as there is no animation delay during parametric solving.