Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Content layer
id57060115


Content column
id57060123


Content block
id57079926

On this page

Table of Contents
maxLevel3
minLevel3


Content block
id57060122

Presentation Mode enables users to present a selected diagram or sequence of diagrams in Full Screen mode without showing the status barline, diagram palette, Model Browser, toolbars, and main menu. Additionally, it helps prevent unintended changes that may occur during a presentation. 

Widget Connector
width700
urlhttps://www.youtube.com/watch?v=tvE0WNWDpZk
height500

Presentation Mode workflow

  1. Using the Content Diagram Wizard, generate the content of diagrams used in the project. 
  2. Using the special Presentation Flow relationship, create a sequence of the selected diagrams on the diagram pane.       
  3. Enter the Presentation Mode to present the chosen diagrams.

  4. Exit the Presentation Mode when you are done. 

Enabled Presentation Mode with a defined sequence of diagrams

Anchor
Creating sequence
Creating sequence
To create a sequence of diagrams


  1. Open the created Content diagram with the displayed diagram content.
  2. Do one of the following:
  3. Connect the selected diagrams in the sequence you want to present them. 

Warning

You can navigate through diagrams that are connected using Presentation Flow only.


Note

Only diagram shapes can be connected in a sequence.


Anchor
Enter presentation mode
Enter presentation mode
To enter Presentation Mode


Do one of the following:

  • In the main menu, click Window > Enter Presentation Mode
  • In the bottom right corner of the status barline, click the Presentation Mode icon.

  • In the smart manipulator toolbar of the diagram you want to present, click the Presentation Mode icon.
Note

You can enter Presentation Mode from any diagram in a defined sequence.


Note

Diagrams cannot be opened in new tabs if Presentation Mode is active.


Anchor
Exit presentation mode
Exit presentation mode
To switch back to the normal mode


Do one of the following:

  • Press the Esc button on your keyboard.  
  • Click X in the diagram tab next to the diagram name. 

Simulation in Presentation Mode

You can show diagram simulations in Presentation Mode as well. Once the simulation is started, a group of buttons for managing a simulation flow appears at the bottom of the window next to the Presentation Mode control buttons (see the diagram below).

To learn more about diagram simulation, click here


Content block
id1408563896

Related pages



...