This is the case when a recovered element is depicted on diagrams of your project.
To remove a recovered element’s symbol, do one of the following
- On a diagram pane, select the symbol. On its smart manipulator toolbar click
 and then select , as shown in the following figure. - On the diagram pane, select the symbol and press Delete.
- In the Active Validation Results panel, right-click the symbol and select Remove Symbol from its shortcut menu.
The symbol of the recovered element is removed from the diagram. | The same diagram can have many symbols of the recovered element. To remove all of them, repeat the same procedure for each symbol. |
| You can use the Remove Symbol command for more than one symbol at a time. If the diagram including the recovered element symbols is non-editable, belongs to the read-only module, is locked by another user, or still not locked, the command will not be applied. |
Using smart manipulator toolbar to remove recovered element’s symbol |